ACI's LOMAX Hard Tri-Fold Cover maximizes your truck bed with a low profile design and maximum protection. LOMAX Tri-Fold Covers are strong, lightweight, secure and stylish, while being easy to use and offering a simple one person installation and removal. Hard folding cover uses strong aluminum panels with durable, watertight, reinforced vinyl coated hinges. The LOMAX panels are made from aluminum alloy used to make commercial trailers and coated with a textured matte black finish to perfectly complement your truck and OEM bed caps. Extruded aluminum channels under the panels keep the hard truck bed cover rigid while reducing weight. Flexible rubber seals, vinyl coated hinges and limited metal-on-metal contact all work together to reduce noise and vibration for a quiet ride.
Features:
- SLEEK, ULTRA LOW PROFILE DESIGN: Sitting less than half an inch above the truck bed, the textured matte black finish of LOMAX Hard Tri-Fold Cover blends with your trucks OEM bed caps for a sharp, clean appearance.
- EASY TO OPERATE: To open, pull cord from either side to release latches; folding each panel automatically disengages additional locks. Then, secure LOMAX Hard Tri-Fold Cover with integrated storage clips. To close, release storage clips and use built-in handle to unfold panels. The tonneau automatically locks at ten points when closed, keeping your cargo protected and out of sight.
- WEATHERTIGHT SEAL: The water-shedding design and waterproof, reinforced vinyl coated hinges route water away from the bed without gutters or drains. The hard folding tonneau overlaps the bed rails with a continuous seal along the entire length of the side rails, preventing elements from entering the truck bed.
- STRONG YET LIGHTWEIGHT: Extruded aluminum channels support the panels to hold up to 400 pounds of evenly distributed weight, while weighing approximately 50 pounds for a high strength-to-weight ratio.
- INTEGRATED STORAGE CLIPS: Sleek, retractable storage clips hold tonneau cover secure and rigid standoffs with rubber pads keep panels properly spaced in the folded position. No adjustments needed.
- SIMPLE INSTALLATION: Install rails with eight TIGHT BITE Clamps. Slide the hard tonneau cover forward to engage hooks, then lower into retainment brackets. Unfold each panel, truck bed cover locks automatically at ten points when closed. No drilling required.
- EASY TO REMOVE AND REINSTALL: With LOMAX Cover open and storage clips secured, pull cord on front panel and slide it back to disengage hooks, then lift to remove. Reinstall by sliding tonneau cover forward to engage hooks, then lower into retainment brackets. This folding truck bed cover automatically locks in place.
LOMAX(TM) Hard Tri-Fold Cover delivers a bold look, taking your truck to new heights. The textured matte black finish and ultra low profile design merge flawlessly with your pickup for a sleek appearance. From the simple install and removal to the strategically placed weather seals, the LOMAX(TM) Hard Tri-Fold Cover is manufactured for superior performance. No such thing as too much detail.
17-ON Nissan Titan 6' 6 Box (w/ or w/o utili-track); 16-ON Nissan Titan XD 6' 6 Box (w/ or w/o utili-track)
Access LOMAX Tri-Fold Cover 16-19 Nissan Titan/Titan XD - 6ft 6in Bed
Titan/Titan XD 6ft. 6in. Box (clamps on w/or w/o utili-track)
Titan/Titan XD 6ft. 6in. Box (w/or w/o utili-track)
HARD TRI-FOLD COVER
LOMAX - Matte Black
Tonneau Cover
LOMAX
Agri-Cover manufactures two types of roll up tonneau covers and a new Tri-fold tonneau cover. Our Access roll up covers & truck tonneau covers give you additional protected storage, while the low profile roll up covers give you a sleek, low profile look. ACI's inventive truck tonneau covers and truck accessories emphasize style, durability, quality, value and functionality. The Lomax Roll Up covers & truck tonneau covers distance themselves from other truck bed covers with superior workmanship, easy installation and simple operation. Agri-Cover's new LOMAX line maximizes your truck with a low profile tri-folding design with maximum protection. The LOMAX Hard Tri-Fold Cover maximizes your truck with a low profile design and maximum protection. This lightweight hard truck bed cover is designed for strength, security and style, while being easy to use and offering a simple one person installation and removal. This hard folding cover uses strong aluminum panels with durable, watertight, reinforced vinyl coated hinges. The panels are made from aluminum alloy used to make commercial trailers and coated with a textured matte black finish to perfectly complement your truck and OEM bed caps. Extruded aluminum channels under the panels keep the hard truck bed cover rigid while reducing weight. Flexible rubber seals, vinyl coated hinges and limited metal-on-metal contact all work together to reduce noise and vibration for a quiet ride.
Agri-cover is an innovator in the world of truck tonneau covers. Based from North Dakota their roots began in the big rig industry making covers for trailers carrying agricultural products. Their incredible fabric design was a great match for the light duty pickup market for covering valuable cargo and stand up to the elements and stresses that come with the life of a pickup. They have expanded their offerings into bed accessories, snow plows, as well as atv and utv markets. If you need a truck bed cover, they are your solution.
Agri-Cover, Inc, (ACI) manufactures Lomax Roll-Up Truck Bed Tonneau Covers and truck accessory products. Since the introduction of the Original Lomax Roll-Up Tonneau Cover in 1991, ACI has led the industry with additional inventive truck bed covers and truck accessories that emphasize style, durability, quality, value and functionality. The Lomax Tonneau Covers distance themselves from other truck bed covers with superior workmanship, easy installation and simple operation. Lomax Roll-Up Covers fit your lifestyle, your truck and your budget!
IMAGES: Images may be a representation and may not reflect the actual product.
California Residents: Prop 65 WARNING: This product MAY contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.P65Warnings.ca.gov
California Residents: TIRE WARNING: LMPerformance will not ship Tires to California.
Legal: Some or all of these parts may not comply with Federal, State, Province, and/or Local laws, ordinances, and regulations. Buyer takes all responsibility to ensure that any modifications or upgrades that have done conform to all applicable laws and regulations for road use, especially pertaining to safety and emissions. LMPerformance is not responsible for buyer not complying with Federal, State, Province, and/or Local laws, ordinances, and regulations. This policy shall be in force for all past, current, and future purchases from LMPerformance, Inc. LMPerformance will not ship ANY non-CARB compliant products to California where California requires products to be CARB certified such as Catalytic Converters and Induction Kits.
FREE SHIPPING: Please note FREE Shipping refers to shipping within the contiguous continental US only. All other locations extra. Some items that require Truck Freight Delivery will require a Truck Freight surcharge. This surcharge is still a discounted shipping amount that is lower then the actual truck freight shipping charge that is charged to LMP. LMP will try to still give the lowest price possible for truck freight items.
IMAGES: Images may be a representation and may not reflect the actual product. Examples would be SPEC stage 3 clutch kits which all use the same photo.
TYPOS: LMPerformance tries to present the best most accurate information on our website. Sometimes we get mistakes in product information sent from vendors such as typos. We can not be responsible for these typos, if you see something that does not look right please let us know before ordering so we can double check for you first. LMPerformance will not pay for typos in any way, monetarily or otherwise.
SPECIAL ORDER ITEMS: Some items are special ordered and may not be returnable, or even cancellable as they are going into production specifically because you ordered them. Special ordered items can have a 5-35% cancelation fee.
Cancellations: Instock orders cannot be canceled due to our automated ordering & fast shipping system. To keep our prices low, all cancelations are subject to a 5% cancelation fee to cover transaction processing fees. We reserve the right to charge up to a 10% cancellation fee for cancelled orders due to merchant fees, special order fees and the cost of processing and shipping orders.When you request a cancellation of an order or a part, please note that it may take time for a manufacturer to cancel an order if the order is drop-shipped. We also have to confirm that the product has not shipped. If the product has shipped then this must be processed as a return.Also note that sometimes products ship more quickly than expected, so we recommend that you do not purchase alternative products until receiving final confirmation of the cancellation.
Returns:We cannot accept returns on parts that have been used or installed. No returns will be accepted after 30 days. All Returns must be in original packaging. Prior authorization must be given before any return can be made. Up to a 25% Restocking Fee may apply. Special orders may be subject to Additional Manufacturer Restock Fees as well. Shipping cost will not be refunded.Hoods as well as PCM Programmers may not be returned unless defective and only for replacement. ALL returns must be first filed using our online form found here: https://www.lmperformance.com/returns.
Lost Order ClaimsAll lost order/package claims must be made within 5 days of the shipping date or tracking information delivery date. All claimes made after this date will not be accepted due to Shipping companies policies of filing loss claims.
Damaged Items or Incorrect Items: Please contact us right away if your item has been damaged in shipping or are incorrect. Please note that we will ship replacement items the same method of shipping the order was originally placed for. LMPerformance can not ship packages overnight at our cost if the original shipping was not also overnight. Claims must be filed in order for replacement parts to be shipped.
Warranties:Any warranty claims must be placed with the manufacturer. All of the products sold by LMPerformance, regardless of the manufacturer, are designed for Racing and Performance applications. Many of our manufacturers offer NO WARRANTY on their products, either stated or implied, due to the unusual stresses placed on the parts and because we have no control over how they are installed and used. Many of these products are designed for off-road use only and are not legal for use on public highways. If you have a question about the warranty on a specific product, please e-mail or call us. Buyer assumes all risk and liability associated with these products.
Installation:We are not responsible for or any costs associated with the installation or the improper installation of any products. Purchaser assumes the risk associated with the installation of products. We, along with the manufacturer of each product are not responsible for any direct or indirect damage to the vehicle, personal, or costs incurred from the use of products.
Starting at 0% Order Now, Pay Later Learn More.
