JLT Cold Air Intake Chevrolet Camaro LT1 6.2L CAIP-CC1662

NOW SHIPPING!

JLT’s New Cold Air Intake kits for the 2016-19 Camaro in textured black plastic finish.
Designed to make huge power this new kit has a large 120mm ID through out the tube, with a 5” bell mouth at the MAF.

This huge 5” opening requires a huge filter. We love the tapered flange design and Powerstack filtered ends of S&B's filters and ended up with a monster 5x7” filter. Finish it off with a silicone reducer and stainless clamps and you got the BEST Intake on the market!!! NO METAL TUBING HERE!!

MOLDED IN MAF
It’s a full 120mm ID at the MAF area.

HEAT SHIELD
Includes ABS plastic heat shield to block engine heat at idle and low speed.
It incorporates the fresh air inlet from the grill.
It uses a large area to make sure the filter has tons of cool air.

KIT INCLUDES:

• JLT Plastic Intake with Black Textured finish
• Silicone Reducer
• 5x7 S&B Powerstack Air Filter
• ABS Heat Shield
• HD Clamps, all needed hardware

All Red Filters are OILED Filters

Up to 25 RWHP & RWTQ ?peakgains, but as high as 36 RWHP and RWTQ have been seen throughout the RPM range when used with our custom tune!

TUNING

A JLT specific tune is required with this kit.

*This product is NOT CARB (California Air Resource Board) Exempt. It is not for legal sale or use in the state of CA or any other states adopting CA emission standards and requires a CA Executive Order (EO) number. Any orders placed for this item with a CA ship to address will be canceled.

JLT cold air intakes are made right here in the USA. JLT PERFORMANCE was founded in 2004 and is located in Chesapeake, Virginia where they manufacture not only primo cold air intakes but impressive oil separators for late model Mustangs, Camaros, Mopars and Ford Trucks.

You know that a cold air intake serves the purpose of moving the air filter outside of the engine compartment and away from unnecessary heat thus it allows cooler air and more oxygen into your car’s combustion chamber and as a consequence your car has more power. But not all cold air intakes are created equal and JLT cold air intakes like the direct replacements for 1996-2004 Mustangs, 1997-2003, 2015-2917 Ford trucks and 2005-2018 Mopar cars will require no tuning. If you have a 2005 and newer Ford or Camaro because JLT has complete packages with tuners and custom tunes so you can install it all at home in less than one hour. You won’t find any choke points nor will there be any accordion style bends resulting in a minimum of restriction with these air intakes and because the JLT intakes only draw air from outside the engine bay your car’s engine gets maximum air density which should improve mileage under almost all driving conditions.

JLT also developed a uniquely designed oil separator that filters and separates the oil in the vapor so that it is deposited into a catch can rather than in your car’s intake system. Although the oil separator will work on any engine JLT looked out for their Ford, Mopar and GM customers in particular by designing a plug and play set up that will work on most applications with PCV lines already attached so installation should only take about a minute..

IMAGES: Images may be a representation and may not reflect the actual product.